Kodak HERO 9.1 Extended User Manual page 18

Networking Your Printer
Connecting to a WPS wireless router
12
If your router supports Wi-Fi Protected Setup (WPS), use WPS Connect. WPS lets
you configure your printer for a wireless network by pressing buttons or entering a
PIN.
To connect to a network using WPS:
1. Press .
2. Touch , then touch Network Settings .
3. Touch Wi-Fi Setup Wizard .
NOTE: The Wi-Fi radio turns on automatically when you select Wi-Fi Setup Wizard.
4. Touch WPS Connect .
5. Select one of two methods of connecting:
Before you make a selection on the printer, make sure you know where the
IMPORTANT:
router's push button is, or where to enter the generated PIN. If necessary,
consult your Internet Service Provider or router device manufacturer's
documentation for more information.
Pressing a button
NOTE: You will have two minutes to
press or select the WPS button. It
may be a button on the device or
a virtual button in the device's
software.
a
Touch Push Button Configuration .
b
Press or select the WPS button for
your wireless router.
c
Touch OK on the control panel.
www.kodak.com/go/aiosupport
Entering a PIN
a
Touch Generate WPS PIN .
b
In your wireless router's software,
locate the PIN screen.
c
Enter the PIN you received on the
LCD into the PIN screen, then
follow the router's instructions.
d
Touch OK on the control panel.