Digital Dubbing - JVC GR-DVM50 Instructions Manual

Lock Button
Open the
connector cover.
To DV
IN/OUT
DV cable
(optional)
To DV
IN/OUT
Video unit equipped
with DV connector
PLAY (4)
STOP (5)
To Use This Camcorder As A Recorder . . .
1. Turn the Power Switch to "
2. Connect the DV cable as shown in the illustration and load a cassette to record on.
3. Press START/STOP to engage the Record-Pause mode. "DV IN" appears on the screen.
4. Press START/STOP to start recording. "DV IN" changes to "
5. Press START/STOP again to engage the Record-Pause mode. "
NOTES:
During Digital Dubbing, the image is dubbed using the recording mode selected in the Mode Menu
( pg. 12).
Digital Dubbing is performed in the sound mode recorded on the original tape, regardless of the current
"SOUND MODE" setting (
During Digital Dubbing, no signal is output from the AV OUT connector.
Power Switch
T W
RM-V713U
(provided)
" while pressing down the Lock Button.
pg. 30).

Digital Dubbing

It is also possible to copy recorded scenes from the
camcorder onto other video unit equipped with a DV
connector. Since a digital signal is sent, there is little if any
image or sound deterioration.
1
CONFIRM POWER-OFF STATUS
Make sure the camcorder's power is off.
2
MAKE CONNECTIONS
Connect the camcorder to your video unit equipped
with a DV connector using the DV cable (optional) as
shown in the illustration.
3
START PLAYBACK
Press 4 to play back the source tape.
4
START RECORDING
While watching the playback on the monitor, engage
the DV connector-equipped video unit's record mode
from the spot on the source tape you want to begin
recording.
NOTES:
It is recommended to use the AC Power Adapter/
Charger as the power supply instead of the battery pack
( pg. 9).
If the remote control is used when both the player and
recorder are JVC video units, both units will perform the
same operation. To prevent this from happening, press
the buttons on both units.
For Digital Dubbing, this camcorder can be connected
only to one device at a time. This camcorder can also be
used as a recorder.
If a blank portion or disturbed image is played back on
the player during dubbing, the dubbing may stop so that
an unusual image is not dubbed.
Even though the DV cable is connected correctly,
sometimes the image may not appear in step 3. If the
above occurs, turn off power and make connections
again.
1
If "Playback Zoom" (
Effects" ( pg. 55) or "Snapshot" is attempted during
playback, only the original playback image recorded on
the tape is output from the DV IN/OUT connector.
Be sure to use a DV cable with the core filter.
DV IN ".
" returns to "DV IN".
DV IN
EN
pg. 54), "Playback Special
51