Intermatic RC2263BE Installation, Operation & Service Manual

RC2000 SERIES
REMOTE CONTROLS
AIR OPERATED CONTROLS FOR POOL - SPA COMBINATIONS
Suitable for Pool Equipment Control and for Direct Connection of Underwater Lights
Model: RC2263E Control Center / Model: RC2263BE Control Panel
One Button Control for Single or Two Speed Filter Pump, Blower Heater and Valves
FILTER PUMP: 1 HP - 120V, 2 HP - 240V; AIR BLOWER: 1 HP - 120V, 2 HP - 240V.
VALVE ACTUATOR: 24V up to 3 Actuators
...do not permit children to operate the Control Unit or use the Pool/Spa unless they are closely supervised at all times.
...test GROUND FAULT protection regularly. If it fails to reset, DO NOT USE THE POOL or SPA!
Contact a qualified service technician immediately.
...always disconnect electricity before servicing this control or the equipment connected to it.
Many of today's pools and spas utilize the advantages of a single
electrical control panel, containing all the necessary components
for the safe, cost effective and automatic operation of a pool or spa.
Model RC2263E is designed to operate the shared equipment, like
the pump, filter and the heater of a Pool-Spa combination safely
from the spa side with only one air button. In addition, the Air
Blower of the SPA can be controlled by the same air button as
shown in the chart below.
The 24 hour timer turns ON the filter pump and automatically filters
and, if so set, heats the pool water on a daily schedule. In addition,
by the push of the #3 air button at the spa side, the Control turns
ON the pump, the heater and rotates the valves thus allowing the
water to circulate in the spa. The Control also features a selector
switch for the heater. The switch has three positions and it can be
set to heat the water either in the spa only or both in the spa and in
the pool to two different pre-selected temperatures. The third posi-
tion disables the heater. the Control also has terminals for connect-
ing a freeze or heater protection thermostat to its filter pump con-
trol logic board.
Model RC2263BE is the same as the one described above,
except it is built into an 8 circuit 100 Amp. sub-panel.
The Control coordinates the operation of the various pool/spa
equipment according to the following table:
EQUIPMENT
Sequence 1 (Home Position)
Filter Pump
One Speed Timer ON/OFF
Low/High Speed Timer Low/Off
Blower OFF
Valves Set to Pool Circulation
Heater
Pool Temperature Setting
DANGER! TO AVOID RISK OF INJURY:
READ, FOLLOW & SAVE THIS INSTRUCTION MANUAL

GENERAL INFORMATION

RC2263E
Sequence 2
ON
High
OFF
Set to Spa Circulation
Spa Temperature Setting
1
INSTALLATION
OPERATION &
SERVICE MANUAL
RC2263BE
Sequence 3 Sequence 4
ON OFF
High Low
ON ON