Download Print this page

Intermatic RC2163E Installation, Operation & Service Manual

Rc2000 series remote controls air operated controls for pool - spa combinations

Advertisement

Quick Links

RC2000 SERIES
REMOTE CONTROLS
AIR OPERATED CONTROLS FOR POOL - SPA COMBINATIONS
Suitable for Pool Equipment Control and for Direct Connection of Underwater Lights
Model: RC2163E Control Center / Model: RC2163BE Control Panel
ONE BUTTON CONTROL FOR FILTER PUMP, HEATER AND VALVES
ELECTRICAL RATING: 20 Amp. Resistive - 120V or 240V; 1.5 HP - 120V, 3 HP - 240V, DPST.
...do not permit children to operate the Control Unit or use the Pool/Spa unless they are closely supervised at all times.
...test GROUND FAULT protection regularly. If it fails to reset, DO NOT USE THE POOL or SPA!
Contact a qualified service technician immediately.
...always disconnect electricity before servicing this control or the equipment connected to it.
Many of today's pools and spas utilize the advantages of a single
electrical control panel, containing all the necessary components
for the safe, cost effective and automatic operation of a pool or spa.
Model RC2163E is designed to operate the shared equipment, like
the pump, filter and the heater of a Pool/Spa combination safely
from the spa side with only one air button.
The 24 hour timer turns ON the filter pump and automatically filters
and, if so set, heats the pool water on a daily schedule. In addition,
by the push of the air button at the spa side, the Control turns ON
the pump, the heater and rotates the valves thus allowing the water
to circulate in the spa. The Control also features a selector switch
for the heater. The switch has three positions and it can be set to
heat the water either in the spa only or both in the spa and in the
pool to two different pre-selected temperatures.
The Control also has provisions for connecting a freeze or heater
protection thermostat to its filter pump control logic board.
Model RC2163BE is the same as the one described above, except
it is built into an 8 circuit 100 AMP. sub-panel.
The Control coordinates the operation of the various pool/spa
equipment according to the following table:
EQUIPMENT
Filter Pump
Heater
Valves
Low Voltage: 24V - 40VA Maximum
DANGER! TO AVOID RISK OF INJURY:
READ, FOLLOW & SAVE THIS INSTRUCTION MANUAL
GENERAL INFORMATION
Sequence 1
POOL MODE
Timer Controlled
If selected, Water Temperature
is as Set by Pool Thermostat
Set to Pool Circulation
SERVICE MANUAL
RC2163E
Sequence 2
SPA MODE
ON - Continuously
Water Temperature
is as Set by Spa Thermostat
Set to Spa Circulation
1
INSTALLATION
OPERATION &
RC2163BE

Advertisement

loading

Summary of Contents for Intermatic RC2163E

  • Page 1 Model RC2163E is designed to operate the shared equipment, like the pump, filter and the heater of a Pool/Spa combination safely from the spa side with only one air button.
  • Page 2 IMPORTANT SAFETY INSTRUCTIONS When installing and operating this Product and other associated equipment, basic safety precautions should always be followed, including the following: 1. Read and follow all instructions. 2. This Control must be installed by a qualified electrician, according to National and Local Electrical Codes. 3.
  • Page 3 Check connections Replace fuse Check power supply Change relay Check pump ENCLOSURE DETAILS RC2163E NOTES: 1. An air button with ruptured seal or bellows inside, will not produce sufficient air pressure to operate the pulse switch and could lead to total breakdown allowing water to enter the air hose.
  • Page 4 Intermatic Incorporated/After Sales Service, 7777 Winn Rd., Spring Grove, IL 60081-9698/815-675-7000 http://www/intermatic.com Because of our commitment to continuing research and improvements, Intermatic Incorporated reserves the right to make changes, without notice, in the specifications and material contained herein and shall not be responsible for any damages, direct or consequential, caused by reliance on the material presented.

This manual is also suitable for:

Rc2263beRc2163be