Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Wahl HEAT SPY R10
Summary of Contents for Wahl HEAT SPY R10
- Page 1 HEAT SPY ® R10 Compact Fixed Infrared Sensor User Manual Palmer Wahl Instruments, Inc. 234 Old Weaverville Road Asheville, NC 28804 Phone: 800-421-2863 • 828-658-3131 Fax: 828-658-0728 Email: info@palmerwahl.com www.palmerwahl.com WD1112 – Rev. C Revised August 2020...
-
Page 2: Table Of Contents
Palmer Wahl Instruments, Inc. Warranty Manufacturer warrants all products listed in this catalog to be free from defects in material or workmanship under normal use and service. The Manufacturer agrees to repair or replace any product, which upon examination is revealed to have been defective due to faulty workmanship or material if returned to our factory, transportation charges prepaid, within the product specific warranty period stated in the catalog by the manufacturer. -
Page 3: Introduction
1. Introduction The Wahl R10 compact infrared sensors are non-contact infrared temperature measurement sensors. They are designed to measure the infrared radiation emitted from an object, and convert it to an electrical signal. This signal can then be processed to determine the surface temperature of the measured object. -
Page 4: Electronic Specification
4.2. Electronic Specification Analog 4 – 20 mA Cable 2 cond. shielded, PVC, R10A = 5 feet, R10A10 = 10 feet Power Supply 24 VDC 4.3. Environmental & Housing Specification Ambient 0° – 70°C (32° – 158°F) w/ Air Cooling 0°... -
Page 5: Mechanical
Failure to completely fill the target area of the pyrometer will result in increased error of the measurement. The dotted circle indicates the field of view. Palmer Wahl offers various mounting brackets as listed in Section 3, which offer various adjustment methods. Additionally, the unit can be mounted in an 18.2mm diameter hole with the included mounting nuts. -
Page 6: Wiring Installation
Excessive electromagnetic interference may induce error into the measurement. To reduce the possibility of this happening, do not place the unit near electrical equipment that generates large amounts of EMI. These are usually apparatus such as motors, switches, controllers and RF transmitters/antennas. -
Page 7: Important Notes
9.2. Trouble shooting See the below chart for troubleshooting tips. If the problem is not remedied, call Palmer Wahl customer service at the number provided at the end of this manual for a Return Material Authorization (RMA) number prior to returning any goods. - Page 8 Palmer Wahl Instruments, Inc. 234 Old Weaverville Road Asheville, NC 28804 Phone: 800-421-2853 • 828-658-3131 FAX: 828-658-0728 Email: info@palmerwahl.com www.palmerwahl.com...