Icom IC-T90A Instruction Manual page 57

D VFO scan with memory channel watch
While scanning in VFO mode, priority watch checks for sig-
nals in the selected memory channel every 5 sec.
• A memory channel with skip information can be watched.
q Select the desired memory channel to be watched.
w Select VFO mode.
e Push [MODE SCAN] for 1 sec. to start a VFO scan. (full
scan, band scan or programmed scan)
r Push [8 SET] for 1 sec. to enter set mode.
t Rotate [DIAL] until "PRIO" appears.
y Push [8 SET] to select the priority watch item.
u Rotate [DIAL] to select the priority watch ("ON") or priority
watch with alert ("BELL").
i Push [VFO] to exit set mode and start the priority watch.
o Push [VFO] while the display shows the VFO frequency to
stop the VFO scan and priority watch.
51.000
850.000
VFO scan
Memory channel
433.500
FM
Watches Mch while
VFO scanning.
433.000
Pauses when a signal
is received in Mch.
145.280
145.260
145.100
145.120
145.140
PRIO
5 sec.
145.200
145.220
145.240
D Memory scan watch
While operating on a VFO frequency, priority watch checks
for a signal in memory channels every 5 sec.
q Select VFO mode; then, set an operating frequency.
w Select memory mode.
e Push [MODE SCAN] for 1 sec. to start a memory scan.
r Push [8 SET] for 1 sec. to enter set mode.
t Rotate [DIAL] until "PRIO" appears.
y Push [8 SET] to select the priority watch item.
u Rotate [DIAL] to select the priority watch ("ON") or priority
watch with alert ("BELL").
i Push [VFO] to exit set mode and start the priority watch.
o Push [VFO] while the display shows the VFO frequency to
stop the watch.
CH-499
CH-400
Memory scan
CH-300
VFO frequency
FM P SKIP
PRIO
CH-200
Watches Mch while
operating on VFO.
CH-100
CH-006
CH-005
7
PRIORITY WATCH
CH-000
CH-001
5 sec.
CH-002
CH-003
Pauses when a signal
is received in Mch.
CH-004
u u
52