I Frequency Skip Function; I Skip Channel Setting - Icom IC-T90A Instruction Manual

6
SCAN OPERATION

I Frequency skip function

Unwanted frequencies can be skipped and programmed as
skip channels when full scan, band scan or programmed scan
is pausing.
q Start a VFO scan. (p. 46)
w While receiving an unwanted signal and scan pauses,
push [5 SKIP] for 1 sec. to program the received frequency
as a skip frequency.
• The transceiver emits 3 beeps and the scan resumes.
• Non-programmed memory channels (blank channels) are used
for skip frequency programming in reverse sequence.
• Do not release [5 SKIP] before 1 sec., otherwise the scan stops
and the transceiver enters frequency setting condition.
When scan pauses.
FM
Flashes while scanning.
To scan the skip frequency after programming, cancel the
skip information or clear the memory channel. (p. 43)
47
Push [5 SKIP] for 1 sec. to program
the frequency as a skip frequency.
P SKIP
FM
Blank channels are used in
reverse sequence.

I Skip channel setting

Memory channels can be set to be skipped for memory skip
scan. In addition, memory channels can be set to be skipped
for both memory skip scan and frequency skip scan. These
are useful to speed up the scan interval.
q Select memory mode with [MR].
w Rotate [DIAL] to select memory channel to set the skip in-
formation.
e Push [5 SKIP] for 1 sec. one or more times to select the
condition.
• "OFF" for no skipping of channels, "SKIP" for memory skip scan
or "P SKIP" for frequency skip scan and memory skip scan.
P SKIP
"P SCAN" setting is effective when the frequency skip func-
tion is turned ON. (p. 46)
Skip indication
FM P SKIP