Icom IC-T7H Instruction Manual page 24

4
ADVANCED FUNCTIONS
D Setting a skip channel
Memory channels can be set to be skipped during memory
scan. This is useful to speedup the memory scan interval.
Select the memory channel to be programmed as a skip
channel:
Push [MR] to select memory mode.
Rotate [DIAL] (or use the keypad) to select a memory
channel.
Push [ SKIP] for 1 sec. to set
(MR)
the memory channel as a skip
channel.
• "SKIP" appears.
Repeat step
channel.
• "SKIP" disappears.
NOTE: Scan edge channels, 1A to 4B, cannot be set to
show "SKIP" settings, however, they will be skipped dur-
ing memory scan.
20
to cancel a skip
D Scan resume condition
The resume condition can be selected as a pause or timer
scan. This setting is common for all scans.
Receiving
a signal
Pause
scan
Timer
MR
scan
10 sec. 2 sec.
Push [ SET] for 1 sec. to enter
(H/L)
SKIP
MR
set mode.
Push [H/L] or [TONE] one or more
times until "SC" appears.
Rotate [DIAL] to select the desired
scan resume condition.
• "T-10": scan pauses for 10 sec. on a
received signal.
• "P-02": scan pauses on a received signal until it disappears.
Push [ CLR] to exit set mode.
(VFO)
SET MODE
USING
When receiving a signal, pause
scan pauses until the signal
disappears; timer scans pauses
for 10 sec.
R