Download Print this page
Humminbird Wide Portable User Manual

Humminbird Wide Portable User Manual

Humminbird wide portable: user guide
Hide thumbs Also See for Wide Portable:

Advertisement

Quick Links

Advertisement

loading

Summary of Contents for Humminbird Wide Portable

  • Page 2: What You Have

    PORTABLE CASE ASSEMBLY Your new Humminbird Portable case incorporates a quick-disconnect mount and connector system for quick and easy removal of your Humminbird unit from he case. The mount allows the unit to tilt 90 degrees for easy viewing from any location.
  • Page 3 Remove the two battery compartment lids by lifting upwards on the front lip. Locate the connector hardware kit and the transducer hardware kit stored in the battery compartments. Refer to the illustration and route the transducer cable through the rear of the mount base. Insert the power and transducer cable into the connector holder.
  • Page 4: Installing The Batteries

    Insert the connector holder assembly into place and use the two # 6-32 x 34 “ screws to fasten it to the mounting bracket. Install the Humminbird unit by sliding it onto the mounting bracket until it is fully seated. All cable connections are made automatically.
  • Page 5: Portable Transducer Assembly

    Any 6-volt lantern battery may be used: however for maximum battery life, we recommend using heavy-duty alkaline batteries. The Humminbird Accessory part number “BAP” allows you the use of 4 “D” cell batteries in place of the lantern battery. This allows the use of rechargeable type batteries to power the portable unit.
  • Page 6 If you choose to install the transducer permanently, additional hardware will be required. Call Humminbird Customer Support for more information. The wing nut allows you to adjust the angle of the transducer in the water so that it points straight down.
  • Page 7 On fiberglass boats it is possible to place the transducer inside the hull of the boat in a pool of water. The sonar signal can pass through the hull of the boat with little signal loss. For ice fishing, Humminbird makes a special bracket to position the transducer at the right height and angle in the water.
  • Page 8: Maintenance

    If the Portable case comes into contact with salt spray, simply wipe the affected surfaces with a cloth dampened in fresh water. Never leave your Humminbird Portable unit in a closed car or trunk- the extremely high temperatur4e generated in hot weather can damage the electronics.
  • Page 9 Repairs should be performed only by authorized Humminbird technicians. HUMMINBIRD ONE YEAR FULL WARRANTY… SERVICE POLICY…. WARRANTY… CUSTOMER SUPPORT…...