Hitachi Global Storage Technologies Handling precautions Set the drive down gently to prevent damage from impact or vibration. Handle the drive carefully by the edges. Do not touch the exposed printed circuit board or any electronic components. Do not press on the top or bottom of the drive.
Page 3
Hitachi Global Storage Technologies Mounting Recommendations The mounting hole locations and size of the drive are shown below: The drive will operate in all axes (six directions) and will stay within the specified error rates when tilted ±5 degrees from these positions. Performance and error rate will stay within specification limits if the drive is operated in the other permissible orientations from which it was formatted.
Page 4
Hitachi Global Storage Technologies Interface connector The figure below shows the physical pin location All pins are in a single row, with a 127 mm (0.050”) pitch. All V5 pins must be terminated. The mating sequence for the case of back-plane blind-mate connector is referred to OEM Spec.
Page 5
Taiwan. Contact Hitachi Global Storage Technologies for further information. Hitachi Global Storage Technologies shall not be liable to third parties for unauthorized use of Hitachi Global Storage Technologies trademarks. References in this publication to Hitachi Global Storage Technologies’ products, programs, or...
This manual is also suitable for:
Travelstar e5k500Hts545050kta300Hts545040kta300Hts545050ktsa01Hts545040ktsa01Hte545050kta300...
Show all