The Built-In Flash Doesn't Work; The Recorded Image Is Blurry; The Recorded Image Is Too Dark - AGFA ePhoto ePHOTO 1280 User Manual

Troubleshooting (cont.)

The built-in flash doesn't work.

The flash may be turned off. Check the
The batteries may be too weak. Replace them.

The recorded image is blurry.

The subject may have moved while you were taking the picture. Hold the camera steady
and take the picture again.
You may have moved the camera before it beeped, signaling that the image was captured.
Take the picture again and hold the camera steady until you hear the beep.
You may have used the wrong
lens and the focus setting match. The flash illuminates subjects up to a distance of only
about 7 feet (2.6 m).

The recorded image is too dark.

There may not be enough light.
The subject may be too far away for the flash. The flash illuminates subjects up to a dis-
tance of only about 8.5 feet (2.6 m).
54
flash setting.
focus setting. Make sure the subject's distance from the
Set the flash to the Auto or Fill-in setting.