Table of Contents
Advertisement
System Setup
Once the speakers have been placed in the
room and connected, the final step in the
setup process is to enter the settings that
configure the AVR65's bass management
system for the type of speakers used in
your system, the calibration of the output
levels and the delay times used by the sur-
round sound processor. Before proceeding
further, this is a good time to review the
installation section of the manual to
make certain that all connections are
properly made.
You are now ready to power up the AVR65
to begin these final adjustments.
1. Plug the
Power Cable fi
unswitched AC outlet.
2. Press the
Main Power Switch 1
in so that it latches in with the "OFF"
wording on the top of the switch
inside the front panel. Note that the
will turn
Power Indicator 3
amber, indicating that the unit is in
the Standby mode.
3. Install the four supplied AAA batteries
in the remote as shown. Be certain to
observe the (+) and (–) polarity
indicators shown in the bottom of the
battery compartment.
AVR65 120 volt Rev (C) 10/6/98
System Configuration
4. Turn the AVR65 on either by pressing
the
System Power Control 2
the front panel, or via the remote by
first pressing the
and then pressing the
c
. The
Power Indicator 3
turn green to confirm that the unit is
on, and the
Information Display ˝
will also light up.
Using the On-Screen Display
While configuring the AVR65 so that it is
properly matched to the specific speakers
in your system, as well as when setting
other system parameters, you may find it
helpful to take advantage of the unit's
on-screen display system. These easy-to-
to an
read displays give you a clear picture of
the current status of the unit, and make
it easy to see which speaker, delay, input
or digital selection you are making.
To view the on-screen displays, make cer-
tain you have made a connection from
the
TV Monitor Video Out
the rear panel to the video input of your
TV, projector or display device. In order to
view the displays, the video source must be
selected as described in the instructions for
the video display.
NOTE: The AVR65's on-screen displays
may only be viewed when the standard,
composite video output is in use. The dis-
plays are NOT visible when the S-Video
signal is displayed.
IMPORTANT NOTE: When viewing
the displays on a projection TV it is
important that they not be left on the
screen for an extended period of time. As
with any video display, but particularly
with projectors, constant display of a static
image such as these menus or video game
images may cause the image to be perma-
nently "burned in" to the CRT. This type
of damage is not covered by the AVR65
17
warranty, and may not be covered by the
on
projector TV set's warranty. Please consult
the owner's manual for your video display
,
for specific information about image
AVR Selector a
button
burn-in.
Power
will
The AVR65 has two on-screen display
modes, "semi-OSD" and "full-OSD".
When making configuration adjust-
ments, it is recommended that the full-
OSD mode be used. This will place a
complete status report or option listing
on the screen, making it easier to view
the available options.
To view the full-OSD screens, press the
OSD
press will bring up the semi-OSD mode
and the second press will turn that mode
off. The third press will call up the full-
OSD display (Figure 1).
The display will appear any time a
change is made to the settings or fea-
jack
on
tures, and it will automatically follow the
‡
command pattern of remote or front
panel instruction. It is not necessary to
use any other navigation buttons to use
the AVR65's On-Screen Display system.
Note that the full screen displays will
time-out after 30 seconds. However, the
on-screen display used with the channel
output level adjustments will remain on
the screen as long as the settings are
being changed. This display must be
manually turned of by pressing the
button
Figure 1
button
three times. The first
o
OSD
.
o
A U D I O
S O U R C E
: D V D
V I D E O
S O U R C E
: D V D
A U D I O
I N P U T
: A N A L O G
T A P E
M O N I T O R
:
O F F
O N
S U R R .
M O D E
: P R O
L O G I C
M U L T I
R O O M
:
O F F
O N
M A S T E R
V O L U M E :
1 9 D B
Hide quick links:
Advertisement
Table of Contents
