Harman Kardon AVR 70 Owner's Manual page 19

AVR70 engelsk manual 11/01/98 11:57
Another group of keys may only be
programmed with one remote code. The
code contained in these keys remains the
same regardless of the source selection.
WARNING: These keys transmit codes
that are vital to the operation of the
product. It is not recommended that they
be programmed with alternative codes, as
it may then be impossible to operate
certain functions of the receiver.
Aux
Cursor Up
⁄
Pro Logic
Delay
Cursor Down
¤
Dolby 3 Stereo
Memo
Cursor Right ›
Movie
Screen Display
Cursor Left ‹
Matrix
Panel Display
Select
Hall
Speaker
Main Volume Up
⁄
Stereo
Test Noise
Main Volume Down
Adjust
Mute
RDS PTY
RDS AF
To program the remote, you need the
remote of the device, whose functions
shall be programmed. Note that it is not
necessary to program all keys, only those
that are required to operate the subject
device. Keys not programmed will retain
the codes preprogrammed at the factory.
Side 13
Remote Control Programming & Operation
1. Slide
Use/Learn a
left corner of the remote to the right so
that it is next to
2. If one of the multi-function buttons
is being programmed press the source
button (i.e.
CD
have this function associated with. If you
are programming a single function key,
proceed to the next step.
3. Press the button on the remote that
is to be programmed. Note that the
Learning y
4. Place the remote head to head with the
remote control whose function is being
learned. The two remotes should be no
more than 8 inches apart.
5. Press and hold the button on the
transmitting remote corresponding to the
function to be memorized until the
LED starts to blink. When the
Learning
LED goes out, release the button on the
transmitting remote. The function code
has been successfully captured.
¤
NOTE: If both LEDs flash during a
programming operation, it indicates that
the remote's memory is full or that
the remote codes from the transmitting
remote are not compatible with the unit's
signal format.
6. Continue to program any additional
remote commands required using steps
2 through 5. When you have finished
programming the remote, slide the
switch to the left so that it
Use/Learn
is in the position.
Use
13
Clearing the Remote Memory
In normal operation, codes for a new
device may be programmed "over"
switch at the top the codes that have been previously
programmed into the remote. It is also
. possible to clear the memory for
Learn
individual keys, or for the entire remote.
When
a memory position is cleared, the remote
, , etc.) you wish to will return to the original factory preset
VCR
command.
To clear the memory for a specific
individual key location, put the
Use/Learn
position. Press the
LED will illuminate. button and the button to be cleared at the
same time. Both the
Learning
momentarily. When
the lights go out, the memory has been
cleared of the user programmed code and
returned to the factory preset. Return the
Use/Learn a
position when you are finished.
To clear the remote's entire memory
and return all keys to their factory preset
commands first put the
switch in the
the
Main Power On
confirm that the
has illuminated. While continuing to
press the
hold the
Learn
seconds. It will then blink twice. Then
release the two buttons. This indicates
that the memory has been cleared of any
user programmed commands and that
the original commands have been
restored. Slide the
back to the
the remote to normal operation.
switch in the
Learn
Main Power Off b
and
Sending
indicators will light
switch to the
Use
Use/Learn a
position. Then press
Learn
button and
b
indicator
y
Learning
button, press and
Power On
button until the
Power Off b
indicator goes off for about 3
switch
Use/Learn
position to return
Use a