8. Use this heater only as described in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock or injury to persons. 9. In order to prevent equipment damage, protect with a ground fault device such as Chromalox STAR-TG series monitor. SAVE THESE INSTRUCTIONS 23-5/8" 11-1/2"...
8. Connect entrance wiring to pigtail leads “L1” and “L2”. Connect ground to screw provided. 9. Inspect to make sure wiring is per “Single Phase Wiring” above. Chromalox STAR series radiant heaters can be field modified by adding optional kits. Refer to Chart A and B to select the proper kit.
Page 4
PGN-15-50 3 Pole, 4 Wire The above plugs are designed to be used with specific ranges of cable diameters. If not used with Chromalox Cable Kits, check cable man- ufacturers cable diameter to be sure plug fits selected cable. Tipover...
7. Remove bulkhead fitting nuts and washers. 8. Remove failed element and replace with a new element. Replace only with genuine Chromalox "Arctic End" ele- ments. Use of other elements will cause excess temperatures inside terminal box.
Page 6
Limited Warranty: Please refer to the Chromalox limited warranty applicable to this product at http://www.chromalox.com/customer-service/policies/termsofsale.aspx. 2150 N. RULON WHITE BLVD., OGDEN, UT 84404 Phone: 1-800-368-2493 www.chromalox.com...
This manual is also suitable for:
Star-02a-11-pcStar-02a-81-pStar-02a-21-pStar-02a-71-pStar-02a-41-pStar-02a-61-p...
Show all