HP Compaq 6000 Pro SFF Troubleshooting Manual page 60

Business pcs
Hide thumbs Also See for Compaq 6000 Pro SFF:
Table of Contents

Advertisement

Table A-2
Diagnostic Front Panel LEDs and Audible Codes (continued)
Activity
iteration but LEDs continue
until problem is solved.
Red Power LED flashes ten
times, once every second,
followed by a two second
pause. Beeps stop after fifth
iteration but LEDs continue
until problem is solved.
Red Power LED flashes eleven
times, once every second,
followed by a two second
pause. Beeps stop after fifth
iteration but LEDs continue
until problem is solved.
System does not power on and
LEDs are not flashing.
54
Appendix A POST Error Messages
Beeps
Possible Cause
10
Bad option card.
11
The current processor
does not support a feature
previously enabled on this
system.
None
System unable to power
on.
Recommended Action
3.
Replace the system board.
4.
Replace the processor.
1.
Check each option card by removing the card
(one at a time if multiple cards), then power
on the system to see if fault goes away.
2.
Once a bad card is identified, remove and
replace the bad option card.
3.
Replace the system board.
1.
Install a TXT capable processor.
2.
Disable TXT in the Computer Setup (F10)
utility.
3.
Reinstall the original processor.
Press and hold the power button for less than 4
seconds. If the hard drive LED turns green, the
power button is working correctly. Try the
following:
1.
Check that the voltage selector (some
models), located on the rear of the power
supply, is set to the appropriate voltage.
Proper voltage setting depends on your
region.
2.
Replace the system board.
OR
Press and hold the power button for less than 4
seconds. If the hard drive LED does not turn on
green then:
1.
Check that the unit is plugged into a working
AC outlet.
2.
Open hood and check that the power button
harness is properly connected to the system
board.
3.
Check that both power supply cables are
properly connected to the system board.
4.
Check to see if the 5V_aux light on the
system board is turned on. If it is turned on,
then replace the power button harness. If the
problem persists, replace the system board.
5.
If the 5V_aux light on the system board is not
turned on, remove the expansion cards one
at a time until the 5V_aux light on the system
board turns on. It the problem persists,
replace the power supply.
ENWW

Advertisement

Table of Contents
loading

This manual is also suitable for:

6000 - proliant - 128 mb ramCompaq 6005 pro mt

Table of Contents