HP OfficeJet G55 Quick Setup Poster
Install the software first
Open the carton.
Remove the HP
If the screen to the left does not
If Windows is using any of your files
Note: On the screen, you may be prompted to
appear, go to the Windows taskbar,
that need to be updated, Windows
enter your cable type.
on and insert
, and then choose
take the Product
will shut down during installation.
CD from the tray.
the Run dialog box, type
A parallel cable is included in your carton.
(substitute your CD-ROM drive letter
Leave your computer off until
However, if your PC is equipped with a USB
View the Product
(Configure your software).
for the "d"), and then click
port and you are using Windows 98/2000, we
Tour to see all the
recommend you purchase and use a high-
features of your
Follow the onscreen installation
new HP OfficeJet.
speed (12Mbps) USB cable to increase
After the tour,
Note: For more information
to finish setup.
Check your PC's documentation to determine
during installation, click the
if you have a USB port.
Help button, if available.
Unpack your HP OfficeJet
Remove the tray from
Remove the print
Rest the box on its
Verify that you have
cartridges from the sides
side and pull out your
these additional key
of the HP OfficeJet.
HP OfficeJet. Remove
any packaging or tape
from the HP OfficeJet.
Connect and secure cables and cords
Parallel Cable Users:
USB Cable Users:
Parallel Cable Users:
Connect the power
Connect your cable.
- or -
supply and the adapter.
Warning: Do not
Connect the parallel
Connect the USB cable from your
Tighten the screws on the cable
cable, then go to
HP OfficeJet to your PC, then go
so that it is securely attached to
connect the USB
parallel cable at
the same time.
Turn on your HP OfficeJet
Insert black print cartridge
Open the door and raise it up until it
Raise both latches on
Remove the black print cartridge (thinner one)
Push the black print cartridge
Lower the right print-cartridge
clicks into place. The print-cartridge
the print carriage.
from its packaging and, being careful to touch
firmly down into the slot on the
latch down onto the top of the
carriage moves to the middle
only the black plastic, gently remove both the
right. As you insert the cartridge,
cartridge, and push down until
green pull tab and the blue tape covering the
make sure the label is facing you.
the latch locks firmly into place.
Do not touch
Turn page over for additional setup.