Maintenance And Servicing - Chicago Electric HVLP-ELECTRIC 97750 Set Up And Operating Instructions Manual

Paint sprayer hvlp-electric
Table of Contents

Advertisement

MAINTENANCE ANd
SERVICINg
Procedures not specifically
explained in this manual
must be performed only by a
qualified technician.
FROM ACCIdENTAL
OPERATION:
Turn the Power Switch (33) of
the Paint Sprayer to its "OFF"
position and unplug the tool
from its electrical outlet
before performing any
inspection, maintenance, or
cleaning procedures.
TO PREVENT SERIOuS
INjuRY FROM TOOL
FAILuRE:
do not use damaged
equipment. If abnormal noise
or vibration occurs, have the
problem corrected before
further use.
Inspection, Maintenance, and
Cleaning
1.
BEFORE EACH uSE,
general condition of the Paint Sprayer
and its accessories. Check for loose
screws, misalignment or binding of
moving parts, cracked or broken
parts, damaged electrical wiring/air
hose, and any other condition that
may affect its safe operation.
2.
IMPORTANT:
be cleaned immediately after each
use. Improper cleaning is a com-
mon reason for the Spray Gun not
to operate properly. Materials dry
SKU 97750
For technical questions, please call 1-800-444-3353.
TO PREVENT
SERIOuS INjuRY
inspect the
The Spray Gun must
quickly which will render the Spray
Gun useless. It is extremely difficult
to remove dry paint/fluid from small
passages within the Gun.
3.
SOLVENT SELECTION:
low the paint/fluid manufacturer's rec-
ommendations for cleaning, solvent
type, and disposing of used solvent.
Oil-based paints/fluids: Use mineral
spirits.
Latex (water-based) paints/fluids:
Use warm, soapy water.
IMPORTANT: Do not use min-
eral spirits on latex (water-based)
paints/fluids or the mixture will
congeal, making it very difficult to
remove.
If a flammable solvent is used, ad-
here to the following: (1) Follow all
of the solvent manufacturer's clean
up instructions and safety precau-
tions at all times. (2) If collecting
flushed solvents into a metal con-
tainer, transfer into a larger non-
metal container, and flush the metal
container.
4.
AFTER uSE:
Empty the Cup (27), and clean it
with solvent for oil-based paint/fluid
or soap and water for water-based
paint/fluid.
Fill the Cup (27) with solvent (or
water) and spray it through the
Gun into a container while shaking
the Gun. Once the Cup is empty,
repeat the process until the solvent/
water comes out clean.
Turn the Power Switch (33) to its
"OFF" position and disconnect from
the electrical outlet. After discon-
necting, be aware that air pressure
Always fol-
Page 11

Advertisement

Table of Contents
loading

Table of Contents