Cutterhead Guard; Belt Guard - Grizzly G1182 Instruction Manual

VIII. ASSEMBLY (Continued)
F. CUTTERHEAD GUARD
To install the Cutterhead Guard:
1. The cutterhead guard pivot shaft is slotted on
the end. This slot fits over the tang at the end
of a spring located in the spring housing. See
Figure 10. Look down the pivot hole to get
an idea where this tang is located.
2. Rotate the spring housing counter clockwise
approximately 1 turn. Insert the guard shaft
into the pivot hole, lining up the slot with the
tang.
3. The cutterhead guard shaft should fit all the
way inside the pivot hole when properly
engaged with the spring tang and should
hold the guard against the fence.
4. The cutterhead guard should be held firmly
against the fence, completely cover the cut-
terhead, and move back into position when
released. If this has not been achieved,
repeat Steps 2-3, increasing the number of
turns on the spring housing to 1
Figure 10. Spring housing.
G1182 6" Heavy-Duty Jointer
G. BELT GUARD
To install the Belt Guard:
Insert the
the belt guard and attach to the jointer base cast-
ing. Do not over tighten. Figure 11.
Figure 11. Belt guard attachment.
1
⁄ .
2
DO NOT attempt any step of assembly,
adjustments, or maintenance while your
Model G1182 is running. Ensure that the
switch is off, power is disconnected and
moving parts have stopped before making
adjustments. Failure to comply may result in
serious personal injury.
5 ⁄ " - 18 x 2 1 ⁄ " mounting bolt through
16 2
-13-