Gigabyte GA-VM900M User Manual page 61

B. View Array Status:
Press F1 to show the array status on the lower screen. If there are no disk arrays then nothing will be
displayed on the screen (Figure 9).
Create Array
Delete Array
Select/Clear Boot Array
Serial Number View
View Array/Disks Status..
Array No. Array Type
Array 0 Stripe
Channel0 Master
Channel1 Master
C. Select Boot Array:
You can select a disk array as boot device if you want to boot operating system from an array. Boot
disk array cannot be selected if the operating system does not boot from the disk array. Highlight the
Select/Clear Boot Array item in Main Menu and press ENTER. Then press ENTER on the target disk
array. The bootable array will be marked with b (Figure 10). If you want to cancel the boot array setting,
press ENTER on the bootable array and its boot setting will be canceled.
Create Array
Delete Array
Select/Clear Boot Array
Serial Number View
Set Boot OK!
Array No. Array Type
(b) Array 0 Stripe
Channel0 Master
Channel1 Master
VIA VT8237S V-RAID Utility V1.20
F1
,
Enter : Confirm the selection
ESC
Stripe Size
64K
ST3120026AS
ST3120026AS
Figure 9
VIA VT8237S V-RAID Utility V1.20
Set/Clear bootable array
F1
,
Enter : Confirm the selection
ESC
Stripe Size
64K
ST3120026AS
ST3120026AS
Figure 10
- 61 -
: View Array/disk Status
: Move to next item
: Exit
Cap. (GB) Status
223.58 Normal
111.79 Stripe0
111.79 Stripe1
: View Array/disk Status
: Move to next item
: Exit
Cap. (GB) Status
223.58 Normal
111.79 Stripe0
111.79 Stripe1
Appendix