Table of Contents
Advertisement
When a Save or Recall function is executed this memory location will be saved as the power up configuration. The
Saved configuration contains 1) Routes, 2) Input Audio and Audio Mutes, 3) Grouping information. The power up
configuration contains 1) Front Panel Lockout status, 2) Serial Mode, 3) A/V Mode, 4) RS-485 Node, 5) Switching
Mode, 7) RGB Delay Time, and 8) IP Address. In other words if a Save or Recall is executed all the above
information is save to flash memory and used the next time the MatrixPRO is powered up.
Adjusting Input Audio Levels
The Audio level is controlled by the Up and Down buttons. To change the volume level, select an Output that is
routed to the desired Input to be changed. Press the Up or Down button to change the level. If the MatrixPro is in
Video only mode, Audio volume levels cannot be adjusted.
Lockout
Lockout prevents the use of the front panel. Front panel lockout will be indicated by the Lockout LED being
illuminated under the Take button. Lockout is set in GUI via serial communication or Ethernet. It can also be
defeated by pressing A/V, Save, and Recall at the same time.
RS-232/485 Mode Switching
Switching between RS-232 and RS-485 is accessed by pressing and holding the ESC/STATUS and pressing 4-8-5
input buttons in that order. Release the ESC/STATUS button and the MatrixPRO will switch to that mode. To enter
the RS-485 node, press and hold the ESC/STATUS key then press input buttons for that node. Nodes range from 1
to 32. Pressing and holding the ESC/STATUS key again allows switching back to RS-232 by pressing 2-3-2 input
buttons.
MP Control GUI
MP Control GUI is an interactive Graphical User Interface application designed to assist users with the operation of
the MatrixPRO.
MP Control Install Instructions
The MP Control software is available on the enclosed CD or may be downloaded from the Folsom Research web-site
or FTP server for the most updated version. The following step-by-step instructions will allow you to install Folsom
Research Inc's MP Control GUI to a Windows NT/2000/XP PC.
Follow the steps below and use the figures provided as a visual reference to the images being displayed during the
installation process.
1.
Double-click on the MPControlSetup.exe to begin the installation process. Click on the 'Next' button to
continue the installation process.
2.
The following dialog box will appear:
12
MatrixPRO 12x - 12 Input Matrix Switcher
Manual # 26-0301000-00 / Revision C
Advertisement
Table of Contents
