Programming Channels Into The Tv's Channel Memory; Programming Channels Automatically; Setting Channel Skip - Toshiba 32DT2U Owner's Manual

Programming channels into the
TV's channel memory
When you press or
or TV control panel, your TV will stop only on the
channels you programmed into the TV's channel
memory.
Follow the steps below to program channels into the
TV's channel memory.

Programming channels automatically

Your TV can automatically detect all active channels
in your area and store them in its memory. After the
channels are programmed automatically, you can
manually add or erase individual channels in the
channel memory.
Note:
• You must configure the ANT/CABLE input
source before programming channels (
page 24).
• The automatic channel programming process
will erase channels that were previously
programmed into the TV's memory.
• To tune the TV to a channel not programmed
in the channel memory, you must use the
Channel Number buttons on the remote
control.
• Programming channels when the
ANT/CABLE input is configured for Cable
will take substantially longer than when the
antenna input is configured for Antenna.
This is normal; however, once channel
programming is finished, you should not have
to repeat the programming process again
unless your Cable TV service lineup changes
significantly.
To program channels automatically:
1無
Configure the antenna input source, if you have
not already done so ( page 24).
2無
and open the Setup menu.
Press
3無
Highlight Installation and press
Chapter 5: Setting up your TV
on the remote control
.
4無
A new set of Installation menu icons will appear,
as shown below. Open the Terrestrial menu,
highlight Channel Program to bring up the Start
Scan, and press
again to begin channel
programming.
The TV will automatically cycle through all the
antenna channels and store all active channels
in the channel memory. While the TV is cycling
through the channels the message "Scanning
channels, please wait" appears.
5無
To cancel channel programming, press
the remote control (or highlight Cancel in the on-
screen display and press
When channel programming is finished, press
or to view the programmed channels.

Setting channel skip

To prevent certain channels from being viewed,
channel positions can be skipped.
1無
From the Setup menu, highlight Installation and
press .
2無
Press p or q to select Channel Options and press
. The list of channels will appear.
on
).
(continued)
25