Page of 2
Download Bookmark Comment

Whirlpool WTW8200Y Product Dimensions

Whirlpool top load washer product dimensions.
Also See for WTW8200Y:
Use and care manual - 40 pages
PRODUCT MODEL NUMBERS
WTW8200Y, WTW8240Y, WTW8400Y,
WTW8440Y, WTW8600Y, WTW8800Y
Installation spacing for recessed area or closet installation
15
(403 mm)
1"
(25 mm)
* Required spacing
The dimensions shown show recommended spacing allowed, with tested spacing of 0" (0 mm) clearance on sides.
■ Additional clearances might be required for wall, door, floor moldings.
■ Additional spacing should be considered for ease of installation and servicing.
■ Additional spacing on all sides of the washer is recommended to reduce noise transfer.
■ For closet installation, with a door, minimum ventilation openings in the top and bottom of the door are required.
Louvered doors with equivalent ventilation openings are acceptable.
■ Companion appliance spacing should also be considered.
"*
7
8
27
/
"
1
2
(699 mm)
(25 mm)
Front view
Top Load Washer
14"* max.
(356 mm)
1"
1"
27"
5"*
(25 mm)
(686 mm)
(127 mm)
Side view
48 in.
*
2
(310 cm
)
2
24 in.
*
2
(155 cm
)
2
Closet door
with vents
3"*
(76 mm)
3"*
(76 mm)

   Also See for Whirlpool WTW8200Y

   Related Manuals for Whirlpool WTW8200Y

   Summary of Contents for Whirlpool WTW8200Y

  • Page 1

    PRODUCT MODEL NUMBERS WTW8200Y, WTW8240Y, WTW8400Y, WTW8440Y, WTW8600Y, WTW8800Y Installation spacing for recessed area or closet installation ⁄ "* (403 mm) 1" (25 mm) * Required spacing The dimensions shown show recommended spacing allowed, with tested spacing of 0" (0 mm) clearance on sides. ■...

  • Page 2

    “Use and Care Guide.” Minimum siphon break: 28" (710 mm) from bottom of washer. (Additional hoses may be needed.) Because Whirlpool Corporation policy includes a continuous commitment to improve our products, we reserve the right to change materials and specifications without notice. Wall standpipe drain system "...

This manual also for:

Wtw8240y, Wtw8400y, Wtw8440y, Wtw8600y, Wtw8800y

Comments to this Manuals

Symbols: 0
Latest comments: