To Add, Reprogram Or Change A Keyless Entry Pin; Using Learn Button - Chamberlain 1345M Owner's Manual

To Add, Reprogram or Change a Keyless Entry PIN

NOTE: Your new Keyless Entry must be programmed to operate your garage door opener.
USING THE "LEARN" BUTTON
1. Press and release the "learn"
button on motor unit. The learn
indicator light will glow steadily
for 30 seconds.
2. Within 30 seconds, enter a four
digit personal identification
number (PIN) of your choice on
the keypad. Then press and
hold the ENTER button.
3. Release the button when the
motor unit lights blink. It has
learned the code. If light bulbs
are not installed, two clicks will
be heard.
To change an existing, known PIN
If the existing PIN is known, it may be changed by one
person without using a ladder.
1 2 3
9 1 9 1
7 3 7 3
5 5
KG KG
1. Press the four buttons for the present PIN, then press
1 2
2. Press the new 4-digit PIN you have chosen, then
The motor unit lights will blink once when the PIN has
been learned.
Test by pressing the new PIN, then press Enter. The
door should move.
To set a temporary PIN
1 2
You may authorize access by visitors or service people
with a temporary 4-digit PIN. After a programmed
number of hours or number of accesses, this temporary
KG
PIN expires and will no longer open the door. It can be
used to close the door even after it has expired. To set a
temporary PIN:
1. Press the four buttons for your personal entry PIN (not
2. Press the temporary 4-digit PIN you have chosen,
3. To set the number of hours this temporary PIN will
3. To set the number of times this temporary PIN will
The opener light will blink once when the temporary PIN
has been learned.
Test by pressing the four buttons for the temporary PIN,
then press Enter. The door should move. If the
temporary PIN was set to a certain number of openings,
remember that the test has used up one opening.To
clear the temporary password, repeat steps 1-3, setting
the number of hours or times to 0 in step 3.
One Button Close: Opener can be closed by pressing
only the ENTER button if the one button close feature
has been activated. This feature has been activated at
the factory. To activate or deactivate this feature press
and hold buttons 1 and 9 for 10 seconds. The keypad
will blink twice when the one button close is active. The
keypad will blink four times when one button close is
deactivated.
36
and hold the # button.
The opener light will blink twice. Release the # button.
press Enter.
the last temporary PIN), then press and hold the ✽
button.
The opener light will blink three times. Release the
button.
then press Enter.
The opener light will blink four times.
work, press the number of hours (up to 255), then
press ✽.
work, press the number of times (up to 255), then
press #.
OR