What You Need To Know; Setting Your Wap3205 To Client Mode - ZyXEL Communications WAP3205 User Manual

Chapter 7 Client Mode

7.3 What You Need to Know

With the exception of the Wireless LAN screens, the LAN, Monitor,
Configuration and Maintenance screens in Client mode are similar to the ones
in Access Point Mode. See
121 of this User's Guide.

7.4 Setting your WAP3205 to Client Mode

Connect your computer to the LAN port of the WAP3205.
1
The default IP address of the WAP3205 is "192.168.1.2". In this case, your
2
computer must have an IP address in the range between "192.168.1.3" and
"192.168.1.254".
Click Start > Run on your computer in Windows. Type "cmd" in the dialog box.
3
Enter "ipconfig" to show your computer's IP address. If your computer's IP
address is not in the correct range then see
information on changing your computer's IP address.
After you've set your computer's IP address, open a web browser such as Internet
4
Explorer and type "http://192.168.1.2" as the web address in your web browser.
Enter "1234" (default) as the password and click Login.
5
Type a new password and retype it to confirm, then click Apply. Otherwise, click
6
Ignore.
The Easy mode appears. Click Expert Mode in the navigation panel.
7
To set your WAP3205 to Client Mode, on the left of the screen, click
8
Maintenance > Sys OP Mode and select Client Mode.
Figure 32 Changing to Client mode
Note: You have to log in to the Web Configurator again when you change modes. As
soon as you do, your WAP3205 is already in Client mode.
70
Chapter 11 on page 115
Appendix C on page 163
through Chapter 12 on page
for
WAP3205 User's Guide