Setting Your Wap3205 To Ap Mode; Configuring Your Wlan, Lan And Maintenance Settings - ZyXEL Communications WAP3205 User Manual

Chapter 6 Access Point Mode

6.3.1 Setting your WAP3205 to AP Mode

Connect your computer to the LAN port of the WAP3205.
1
The default IP address of the WAP3205 is "192.168.1.2". In this case, your
2
computer must have an IP address in the range between "192.168.1.3" and
"192.168.1.254".
Click Start > Run on your computer in Windows. Type "cmd" in the dialog box.
3
Enter "ipconfig" to show your computer's IP address. If your computer's IP
address is not in the correct range then see
information on changing your computer's IP address.
After you've set your computer's IP address, open a web browser such as Internet
4
Explorer and type "http://192.168.1.2" as the web address in your web browser.
Enter "1234" (default) as the password and click Login.
5
Type a new password and retype it to confirm, then click Apply. Otherwise, click
6
Ignore.
The Easy mode appears. Click Expert Mode in the navigation panel.
7
To use your WAP3205 as an access point, on the left of the screen, click
8
Maintenance > Sys OP Mode and select Access Point mode.
Figure 28 Changing to Access Point mode
Note: You have to log in to the Web Configurator again when you change modes. As
soon as you do, your WAP3205 is already in access point mode.

6.3.2 Configuring your WLAN, LAN and Maintenance Settings

• See Configuration (95)
and LAN settings.
• See Maintenance and Troubleshooting (119)
Maintenance settings.
62
Appendix C on page 163
for information on the configuring your wireless network
for information on configuring your
for
WAP3205 User's Guide