Resetting The Wap3205 To Its Factory Defaults - ZyXEL Communications WAP3205 User Manual

Wireless n access point
Hide thumbs Also See for WAP3205:
Table of Contents

Advertisement

The Internet connection is slow or intermittent.
There might be a lot of traffic on the network. Look at the LEDs, and check
1
1.5 on page
closing some programs that use the Internet, especially peer-to-peer applications.
Check the signal strength. If the signal strength is low, try moving the clients
2
closer to the AP if possible, and look around to see if there are any devices that
might be interfering with the wireless network (for example, microwaves, other
wireless networks, and so on).
Reboot the WAP3205.
3
If the problem continues, contact the network administrator or vendor, or try one
4
of the advanced suggestions.
Advanced Suggestions
• Check the settings for QoS. If it is disabled, you might consider activating it.
13.4 Resetting the WAP3205 to Its Factory
Defaults
If you reset the WAP3205, you lose all of the changes you have made. The
WAP3205 re-loads its default settings, and the password resets to 1234. You have
to make all of your changes again.
You will lose all of your changes when you push the RESET button.
To reset the WAP3205,
Make sure the power LED is on.
1
Press the RESET button for longer than 1 second to restart/reboot the WAP3205.
2
Press the RESET button for longer than five seconds to set the WAP3205 back to
3
its factory-default configurations.
WAP3205 User's Guide
20. If the WAP3205 is sending or receiving a lot of information, try
Chapter 13 Troubleshooting
Section
137

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents