Reset/Restart Screen - ZyXEL Communications WAP3205 User Manual

Chapter 12 Maintenance
Table 48 Maintenance > Backup/Restore
LABEL
Upload
Reset
Note: If you uploaded the default configuration file you may need to change the IP
address of your computer to be in the same subnet as that of the default
WAP3205 IP address (192.168.1.2). See
on how to set up your computer's IP address.

12.8 Reset/Restart Screen

System restart allows you to reboot the WAP3205 without turning the power off.
Click Maintenance > Reset/Restart to open the following screen.
Figure 72 Maintenance > Reset/Restart
Click Restart to have the WAP3205 reboot. This does not affect the WAP3205's
configuration.
128
DESCRIPTION
Click Upload to begin the upload process.
Note: Do not turn off the WAP3205 while configuration file upload is in
progress.
After you see a "configuration upload successful" screen, you must then
wait one minute before logging into the WAP3205 again. The WAP3205
automatically restarts in this time causing a temporary network
disconnect.
If you see an error screen, click Back to return to the Backup/Restore
screen.
Pressing the Reset button in this section clears all user-entered
configuration information and returns the WAP3205 to its factory
defaults.
You can also press the RESET button on the rear panel to reset the
factory defaults of your WAP3205. Refer to the chapter about
introducing the Web Configurator for more information on the
RESET button.
Appendix C on page 163
WAP3205 User's Guide
for details