Table of Contents
Advertisement
The mixer in audio interface mode
In audio interface mode you can make a mix for monitoring using the R24's internal
mixer. In addition, you can adjust the balance of the internal mixer and the sound from
the computer.
Volume, reverb send, pan
You can be adjust the reverb send, pan, vol-
ume and stereo link settings as in recorder
mode.
Operation is the same as in recorder mode
(Reference: OPERATION MANUAL)
PAN/EQ menu
VOLUME
Adjust the volumes of INPUTS 1~8.
REV SEND
Adjust the reverb send levels of INPUTS 1~8.
PAN (BALANCE)
Adjust the pan for INPUTS 1~8.
25
0~127 (increments of 1)
Default value: 100
0~100 (increments of 1)
Default value: 0プ
Reverb only affects the
monitored signal (as in
recording mode)
L100~R100
(increments of 2)
Default value: Center
(as in recording mode)
Stereo link
Link even and odd numbered INPUTS to handle
them as stereo pairs.
On/Offプ
Default setting: Off
By setting up a stereo link, volume, reverb send and pan
track parameters can be shared by pairs of even and odd
inputs simultaneously (as in recording mode)
(Reference: Operation Manual)
Balance knob
In audio interface mode, the balance of the in-
put monitoring signal and the signal from DAW
software (the computer) can be adjusted with
the BALANCE knob.
Left
Only the INPUT
1~8 signals
NOTE
The reverb send, pan, volume and stereo link
settings are all saved when you terminate (EXIT)
audio interface mode and can be used again the
next time.
Right
Only the DAW
stereo signal
Hide quick links:
Advertisement
Table of Contents
