Yamaha MU5 Owner's Manual page 71

The device making the dump request must include the corresponding parameter
header for each data type (listed below). For example, if only one dump request
header is used to request both System and Multi Part data, the MU5 will transmit
only the System data.
• System
• Multi Part
• Reset All Parameters
• System Information
4.6.1 System Data Parameter Change
Refer to charts 1-1 and 1-2 on pages add-21 and add-22.
4.6.2 Multi Part Data Parameter Change
Refer to charts 1-1 and 1-3 on pages add-21 and add-22.
4.6.3 System Information Parameter Change
When a dump request is received, data can be transmitted but not received.
Refer to charts 1-1 and 1-4 on pages add-21 and add-23.
4.7 Yamaha TG100 Dump Request
The MU5 responds to portions of a dump request from the TG100. If the parameter
ranges of both devices are the same, the data transmitted and received remains in its
original state. If both devices have the same function yet their parameter ranges are
different, the MU5 reformats the data before transmitting it.
• System parameters
• Multi Part parameters
add-
20
MASTER TUNE
TRANSPOSE
DEVICE NUMBER
MASTER VOLUME
VOICE BANK
PC VALUE
RX.CHANNEL
MONO/POLY MODE
DETUNE
NOTE SHIFT
VOLUME
VELOCITY SENSE
PANPOT
NOTE LIMIT LOW
NOTE LIMIT HIGH
LFO SPEED
LFO DEPTH
LFO DELAY
EG. ATTACK RATE
(Format is changed)
(Format is changed)