Yamaha MU5 Owner's Manual page 69

4.4.4 Reset All Parameters
11110000 F0
01000011 43
0001nnnn 1N
00101011 44
00000000 00
00000000 00
01111111 7F
00000000 00
00000001 01
11110111 F7
This is used to reset all System parameters to their factory-set initial values. Since
one of these messages takes about 120 msec to process, allow a sufficient amount of
time before transmitting the next message.
4.5 TG100 Native Parameter Change
The MU5 receives and responds to the following TG100 parameter changes:
• System parameters
• Multi Part parameters
If only Master Tune is received, the MU5 does not confirm with checksum.
The MU5 does not respond to the following parameters:
• System parameters
add-
18
= Exclusive status
= YAMAHA ID
= Device number
= MU5 Model ID
= Start address 1st byte
= Start address 2nd byte
= Start address 3rd byte
= Data
= Checksum
= End of exclusive
MASTER TUNE
TRANSPOSE
DEVICE NUMBER
MASTER VOLUME
VOICE BANK
PC VALUE
RX.CHANNEL
MONO/POLY MODE
DETUNE
NOTE SHIFT
VOLUME
VELOCITY SENSE
PANPOT
NOTE LIMIT LOW
NOTE LIMIT HIGH
LFO SPEED
LFO DEPTH
LFO DELAY
EG. ATTACK RATE
EG. RELEASE RATE
PITCH BEND RANGE
MOD LFO PITCH DEPTH
CHANNEL AFTER TOUCH PITCH CONTROL
EXCLUSIVE RECEIVE SWITCH
PROGRAM CHANGE RECEIVE SWITCH
CONTROL CHANGE, VOLUME, EXPRESSION
SOUND MODULE MODE
(Not received for Voice #8)
(Negative values are ignored.)