Whirlpool WTW4800X Dimensional Information

PRODUCT MODEL NUMBERS
WTW4900X, WTW5500X,
WTW5550X, WTW5600X,
WTW5640X, WTW5610X
WTW5700X, WTW4750Y,
WTW4800X, WTW4910X
WTW4950X,
Electrical: A 120 volt, 60 Hz., AC only, 15- or 20-amp,
fused electrical supply is required. A time-delay fuse
or circuit breaker is recommended. It is recommended
that a separate circuit serving only this washer be
provided.

DRAIN SYSTEM

Floor standpipe drain system
4 1 "
/
2
30"
(114 mm)
(762 mm)
Minimum diameter for a standpipe drain: 2" (51 mm).
Minimum carry-away capacity: 17 gal. (64 L) per minute.
Top of standpipe must be at least 39" (990 mm) high;
install no higher than 96" (2.44 m) from bottom of washer.
If you must install higher than 96" (2.44 m), you will need
a sump pump system.
Wall standpipe drain system
4 1 / "
2
(114 mm)
See requirements for floor standpipe drain system.
Floor drain system
Floor drain system requires a Siphon Break Kit
(Part Number 285834), 2 Connector Kits (Part
Number 285835), and an Extension Drain Hose
(Part Number 285863) that may be purchased
separately. To order, please see toll-free phone
numbers in your Use and Care Guide. Minimum
siphon break: 28" (710 mm) from bottom of
washer. (Additional hoses may be needed.)
Because Whirlpool Corporation policy includes a continuous commitment to improve
our products, we reserve the right to change materials and specifications without notice.
Top-Loading Washer
Washer dimensions
27
(699 mm)
42"
(1067 mm)
14" max.
(356 mm)
5"
(126 mm)
1"
(25 mm)
Dimensions show recommended spacing allowed, except for closet door ventilation
openings which are minimum required. This washer has been tested for installation with
spacing of 0" (0 mm) clearance on the sides. Consider allowing more space for ease of
installation and servicing, and spacing for companion appliances and clearances for walls,
doors, and floor moldings. Add spacing of 1" (25 mm) on all sides of washer to reduce
noise transfer. If a closet door or louvered door is installed, top and bottom air openings in
door are required.
Laundry tub drain system
4 1 "
/
2
(114 mm)
30" 30"
(762 mm) (762 mm)
Dimensions are for planning purposes only. For complete details, see Installation
Instructions packed with product. Specifications subject to change without notice.

OVERALL DIMENSIONS

/ "
1
27"
2
(686 mm)
For closet installation, with a door,
the minimum ventilation openings
in the top and bottom of the door
are required. Louvered doors with
equivalent air ventilation openings
are acceptable.
17"
(432 mm)
1"
(25 mm)
3"
(76 mm)
48 in. 2
(310 cm 2 )
24 in. 2
(155 cm 2 )
3"
(76 mm)
Minimum capacity: 20 gal. (76 L).
Top of laundry tub must be at least
39" (990 mm) above floor; install
no higher than 96" (2.44 m) from
bottom of washer.
IMPORTANT: To avoid siphoning,
no more than 4.5" (114 mm) of drain
hose should be inside standpipe or
below the top of wash tub. Secure
drain hose with cable tie.
W10240509C
02/2012