Table of Contents
Advertisement
Network settings
Any change made to this page will make the system restart to validate. Make sure every field is correctly
typed before clicking on
.
To eliminate incautious mistakes during installation, NetworKam will stay in installation mode whenever
it starts unless "Reset network at next boot" is disabled. This option can also be disabled using the
Installer program. Once the option is disabled, NetworKam will skip installation at the next boot and the
Installer program will not find the installed units. That implies that NetworKam cannot be accessed if no
one remembers the IP address, except by restoring factory default settings. However, with this option
disabled NetworKam can automatically operate normally after restarting in case of losing power. This
option is ignored in the PPP connection.
Administrators may modify the network settings to fit into existing networks. Some broadband service
45
www.vivotek.com
T: 886-2-22404099
F: 886-2-22404097
Advertisement
Table of Contents
