Lon System - TEC SL-9000 Owner's Manual

11. PROGRAMMING PROCEDURES

11.15 LON SYSTEM

Menu Page: 2
Item No.: 4
The SL-9000 scales which consists of a master, satellites, and a backup master are connected each
other by the LON cable to transmit data such as PLU, ING., NUTRI, etc.
ID# 1 is reserved for the master terminal.
ID# 2 is reserved for the backup master terminal or satellite terminal.
ID# 3 to 32 are for satellite terminals.
Setting numbers other than the above results in an error.
<MENU>
Page 2
ID#: 1
m
NOTES: 1. Before starting the above procedure, press the
mode.
2. When installing the backup master terminal, set the master scale's initial status
of #9-1 to 1.
3. Set ID # to all scales connected by LON cable.
4. When the display power is turned on, a satellite terminal is ready to receive data
from the master terminal.
5. After setting the ID #, turn the power switch OFF and ON again.
m
4
◇
IN-LINE OFF-LINE
Set the number of
scales in the system.
<MENU>
PROG.
Page 2
Main
ESC.
<MENU>
CHANGE
ID #
PLU
DLL?
ENTER
No
11-24
11.15 LON SYSTEM
ENTER
Yes
n
p
key and enter IN-LINE