TEC SL-9000 Owner's Manual page 23

9. REMOVAL AND REPLACEMENT OF MEDIA
4. Insert the tip of the receipt/label into the print head.
5. Align the two media guides with the right edge of the receipt/label.
6. Thread the receipt/label as shown below.
When using a label roll, take up the backing paper onto the winding roll and fix it with the backing
paper stopper.
NOTE: Labels and receipts should be left-aligned as viewed from the front of the machine, and
always threaded in parallel with the media shaft and the print head. Failure to do this may
cause a paper jam or a skew feed.
7. Turn the head-up lever to the arrow indicating direction to set the print head in position.
(Lebel threading method)
Print Head
Backing Paper Stopper
8. Close the printer cover.
9. Finally press the Feed key to confirm that the labels/receipts are loaded correctly.
Media Guide
Head-up Lever
Winding Roll
(Receipt threading method)
Head-up Lever
Label
9- 2
9. REMOVAL AND REPLACEMENT OF MEDIA
Media Guide
Receipt