Power On / Off; Feature - Toshiba 42HM66 Owner's Manual

Power ON
Operation status
. Plug the power cord into a 0V outlet.
. Press the POWER button on the TV
side panel.
. Power ON successful.
Power OFF
Operation status
. Press the POWER button on the TV
side panel.
Note: Allow at least 40 seconds for the lamp
to cool down before you press the POWER key
a second time to turn off the TV.
. Power OFF successful.
Setting the Quick Restart™ feature
When the Quick Restart™ feature set to YES, the TV will stay in
Low Power Shutdown mode for several minutes after the TV is
turned off.
When the Quick Restart™ feature set to YES and the TV is
turned on from Low Power Shutdown mode, the picture appears
immediately. (See "Important notice about hot lamp restart," at
right.)
To set the Quick Restart™ feature:
. Press MENU, and then press ▲ or ▼ until the SETUP menu
appears.
2. Press ► and then press ▲ or ▼ to highlight Quick Restart™.
3. Press ► to select either YES or NO and press ENTER.
Note:
If Quick Restart™ is set to NO and you turn off the TV, it can take a few minutes
for the picture to appear when you turn on the TV again.
If Quick Restart™ is set to YES and you turn off the TV, the following will occur for
a few minutes:
• The screen (lamp) lights dimly.
• The fans continue to run.
This is a function of the Quick Restart™ Low Power Shutdown mode and is not a
TV malfunction. If you do not prefer this, set the Quick Restart™ feature to NO.
When the Quick Restart™ feature is set to NO, if you repeatedly turn the TV on
and off in a short period of time, the useful service life of the lamp may be shorter
than the average useful service life.
TV status
TV is off
(no picture).
TV is turning on
(no picture).
Picture on screen.
TV status
Lamp cooling.
TV is off
(no picture).
Copyright © 2006 TOSHIBA CORPORATION. All rights reserved.

Power ON / OFF

"Ready" LED POWER LED
Not lit. Solid orange.
Flashing orange. Solid green.
Not lit. Solid green.
"Ready" LED POWER LED
Flashing orange. Solid orange.
Not lit. Solid orange.
IMPORTANT NOTICE ABOUT
HOT LAMP RESTART
When the TV has been powered on long
enough for the lamp unit to get hot, it may
take several minutes for the picture to
appear in the following situations:
• When the Quick Restart feature
is set to NO and your turn the TV
off and then on again within a few
minutes; or
• If the TV is on when a short-term
power failure, power surge, or other
similar power failure occurs, such
that the TV loses and regains power
within a few minutes.
This is a property of DLP TV lamp
technology and is NOT a sign of malfunction.
If this occurs, the power and the lamp LEDs
on the TV will blink until the TV is finished
restarting the lamp and the normal picture
appears.
6
9