Cobra 602-2601 Instruction Manual

23801 E. La Palma Ave., Yorba Linda, CA 92887 Ph. 714.692.8180 Fax. 714.692.5016
Items Supplied
>
1 - DETACHABLE BIG RACK
Instruction Manual >
Read all instructions carefully and completely before installing your new Rack!
NOTE: See FIGURE 1. This Cobra detachable rack must be installed after the Cobra rear mounting kit
(P/N 602-2103) or the Harley-Davidson rear mounting kit (P/N 53804-06). Compatible with Cobra
Detachable Backrest (P/N 602-2012 or 602-2212).
Check the fitment of the detachable rack on the bike, attaching it by following steps #2-4
1.
below. All of the front and rear slots (indicated in FIGURE 1) of the rack should fully engage
with both the rear and front plastic mounting bushings (as indicated in FIGURE 2) of the rear
docking kit on both sides of the bike. If any do not, loosen any hardware necessary in order
to adjust the locations for the mounting bushings for the front docking kit until they do. Re-
torque any loosened hardware to their specified torques, then detach the rack from the bike.
Slide the front slots (indicated in FIGURE 1) of the rack into the front mounting bushing of
2.
the rear mounting kit (indicated in FIGURE 2). Make sure to insert the front slots all the way
onto the bushings.
Slowly rotate the rack downward until the rear slots (indicated in FIGURE 1) slip over the
3.
rear mounting bushings (as indicated in FIGURE 2).
See FIGURE 2. Pull backward on both detachable latch knobs and then push downward on
4.
the rack to allow the rack's slots to sit completely in both the front and rear mounting
bushings. Then release the detachable latch knob to fully engage the latch pin underneath
the rear mounting kit bushing.
Before each ride, ensure that the detachable latches are fully engaged underneath the rear
5.
mounting bushings (as indicated in FIGURE 2).
Check the tightness of all the screws before and after the first ride,
6.
and after the first 500 miles.
DOCUMENT NO. 0017 REV. A
11/21
INITIAL INSTALLATION PROCEDURE
DETACHABLE RACK ATTACHING PROCEDURE
Application(s) >
HARLEY:
DRESSER
-MAY HAVE INTERFERENCE
WITH REAR MOUNTED ANTENNAS
-MAY HAVE INTERFERENCE WITH EU
REGISTRATION PLATES
602-2601 / 602-2601B
1
www.cobrausa-vtwin.com
1997-2008
Page 1 of 2