operation when the audio recording mode selected on
this unit does not coincide with that of the loaded tape.
EDIT MODE: Lights when this unit is set in editing mode
such as assemble editing or insert editing under the
control of either an editing control unit connected to
the REMOTE connector or device connected to the
HDV/DV connector on the rear panel (see page 21).
d Repeat (repeat playback) indicator
Lights when the REPEAT MODE menu item (see
page 73) is set to ON to enable the repeat playback
function.
e Time data type indicator
Indicates the type of time data currently shown in the time
counter display.
TC: SMPTE timecode
UB: User bit data
CNT: Count value of the time counter
VITC: VITC timecode
VIUB: VITC user bit data
f VITC indicator
Lights when VITC is being read or recorded regardless of
time data shown in the time counter display.
g Recording/playback signal format display
Indicates the recording/playback video format.
h HD-SDI output format display
When converting the recording signal format on the tape
for output from the HD-SDI OUT connector, this shows
the signal format of the HD-SDI output.
i Input signal display
Indicates the signal formats of video and audio inputs
selected with the buttons (i.LINK, VIDEO, CH1 1/2, CH2
3/4) in video/audio input selection section.
First (top) line: Video area (Indicates the signal format of
video input.)
Second and third lines: Audio area (Indicates the signal
formats of the audio inputs.)
When there is no signal in the selected input, the
corresponding input signal indication flashes.
Note
The indicators without the corresponding option board
installed in the unit do not light.
• When i.LINK input is selected:
Indicator in video
Signal format
area
i.LINK:HDV
The digital video and audio signals in
i.LINK-compliant HDV format are
selected.