Using Ac Power - Sony PMW-500 Operation Manual

1 BP-GL95/GL65/L60S/L80S
2 Align these lines.
2
Slide the battery pack down until its
"LOCK" arrow points at the matching
line on the camcorder.
1 "LOCK" arrow
2 Matching line on the camcorder
Note
If the battery pack is not attached correctly, the terminal
may be damaged.
To detach the battery pack
Holding the release button in, pull the battery
pack up.
36
Preparing a Power Supply
Notes
• During recording and playback (while the ACCESS
lamp on the right-side panel is lit in blue and the
ACCESS lamp in the card slot section is lit in orange),
be careful never to remove the battery pack.
• Make sure to power the camcorder off before replacing
the battery pack.

Using AC Power

Mount an AC-DN2B/DN10 on the camcorder in
the same way as a battery pack, then connect to
the AC power supply.
The AC-DN2B/DN10 can supply up to 100 W of
power.
To an AC outlet
Release button