Pyramid TIMETRAX 42689 Installation Instructions

TIMETRAX™ SYNC CLOCK WASH DOWN ENCLOSURE
Installation Instructions 42689, 42690
OVERVIEW
Thank you for choosing a TimeTrax™ Sync Clock Wash-Down Enclosure (42689/42690). This lightweight, durable
plexiglass enclosure kit is used to protect analog or digital wall clocks from dust, dirt, grime, debris & splash in harsh
indoor environments. The enclosure features a gasket for sealed installation and is NEMA 4 compliant. Enclosure is
constructed with pre-drilled holes for easy mounting.
Model
42689
42690
The wash down enclosure is also suitable for lights, signs and other devices.
For more information, visit pyramidtimesystems.com or call our technical support team at 888.479.7264 during
regular business hours: 8am-5pm EST, M-F.
KIT CONTENTS
42689
Digital Wash Down Enclosure
ASSEMBLY & INSTALLATION
INSTALLATION
Center wash down enclosure over clock. Adjust as required to level the Enclosure. A torpedo level is
recommended. Mark the location of the six mounting holes.
Remove enclosure & drill holes at marked locations using a 1/6in drill bit. If wall anchors (included) are
used, drill hole size as per wall anchor instructions.
Replace the enclosure over the clock & attach to wall with six #10 screws (included). Be sure to tighten
screws enough to create a seal between gasket & wall surface.
NOTE:
Tighten the screws to slightly compress the gasket. Over tightening may cause the gasket not to seal in areas between screws.
If enclosure is to be used with a clock installed on a masonry wall or irregular surface, sealant is required. Place a bead of clear
silicone caulk on gasket. Quantity or thickness of the caulk bead is determined by degree of surface irregularity.
I2258
Page 1 of 2
888.479.7264
pyramidtimesystem.com
Use With
Digital Clocks
13in Analog Clock
42690
Analog Wash Down Enclosure
Mounting Screws (6)