Sanyo CH0971 Technical & Service Manual page 91
Dc inverter split system air conditioner
Hide thumbs
Also See for CH0971:
- Submittal data (2 pages) ,
- Specifications (2 pages) ,
- Installation instructions manual (24 pages)
Table of Contents
Advertisement
Loose wiring may cause the
WARNING
terminal to overheat or result
in unit malfunction. A fire
hazard may also exist.
Therefore, be sure all wiring
is tightly connected.
When connecting each power wire to the corresponding
terminal, follow the instructions “How to connect wiring
to the terminal” and fasten the wire securely tight with
the fixing screw of the terminal plate.
How to connect wiring to the terminal
a) For Indoor Unit
(1) Cut the wire end with a cutting pliers, then strip the
insulation to expose the wire about 9/32" (7 mm).
See the label (Fig. 28) near the terminal plate.
(2) Using a screwdriver, loosen the terminal screw on
the terminal plate.
(3) Insert the wire and tighten the terminal screw com-
pletely using a screwdriver.
b) For Outdoor Unit
I For solid core wiring (or F-cable)
(1) Cut the wire end with a cutting pliers, then strip the
insulation to expose the solid wire about 15/16" (25
mm). (Fig. 29)
(2) Using a screwdriver, remove the terminal screw(s)
on the terminal plate.
(3) Using the pliers, bend the solid wire to form a loop
suitable for the terminal screw.
(4) Shape the loop wire properly, place it on the termi-
nal plate and fix it securely with the removed termi-
nal screw using a screwdriver.
I For stranded wiring
(1) Cut the wire end with a cutting pliers, then strip the
insulation to expose the stranded wiring about 3/8"
(10 mm) and tightly twist the wire ends. (Figs. 30
and 31)
(2) Using a screwdriver, remove the terminal screw(s)
on the terminal plate.
(3) Using a ring connector fastener or pliers, securely
clamp each stripped wire end with a ring connector.
(Fig. 30)
(4) Place the ring connector wire, and replace and
tighten the removed terminal screw using a screw-
driver. (Fig. 32)
9/32"
(7 mm) (ACTUAL
STRIP
SIZE)
SIZE
Fig. 28
Solid wire
Loop
Insulation
Fig. 29
Stranded wire
Ring
connector
Fig. 30
Twist wire ends
Fig. 31
Special
Screw
washer
Screw and
special washer
Ring connector
Terminal plate
Ring
Wire
connector
Wire
Fig. 32
Page 12
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
