Checking The Water Dispenser Line - Samsung RF4287HARS User Manual

cHEcKing tHE wAtER DiSPEnSER LinE

A water dispenser with a filter is one of the helpful features on your new refrigerator. To help promote better
health, the water filter removes unwanted particles from your water. However, it does not sterilize or
destroy microorganisms. You may need to purchase a water purifying system to do that.
In order for the ice maker to operate properly, a water pressure of 20~125 psi is required.
Under normal conditions, a 170 cc (5.75 oz.) cup can be filled in about 10 seconds.
If the refrigerator is installed in an area with low water pressure (below 20psi), you can install a booster pump to
compensate for the low pressure.
After you have connected the water line, make sure the water storage tank inside the refrigerator is properly
filled. To do this, press the water dispenser lever until the water runs from the water outlet.
Water line installation kits are available at extra cost from your dealer. We recommend using a water line
installation kit that contains copper tubing and ¼" compression nut.
Connecting to the water supply line
1. First, shut off the main water supply.
2. Locate the nearest cold water drinking line and install the
pipe clamp and shut off valve.
3. Connect the water line installation kit to
shut off valve.
20_ setting up
Cold water line
Shut off valve
Cold water line
Pipe clamp
Shut off valve
Pipe clamp
Water line installation kit