n
Note: Weather Priority does not work in all scanning modes. See
the following table for Weather Priority operation.
Normal Priority
is ON and WX
Priority is ON
Checks both
Normal Priority
channel and WX
Scan (Play)
Priority chanel
Mode
Alert displays
when 1050Hz
tone is detected
Signal Stalker II
No Priority
Mode
Operation
No Priority
Search Mode
Operation
No Priority
WX Mode
Operation
While Browsing
No Priority
Objects
Operation
(-Browser- is
displayed)
To set the Weather Priority channel:
1. Press
, then press or to select the strongest NOAA
channel for your area.
2. Press MENU and scroll to
Priority
3. Press or to select the NOAA weather radio channel that you
identified in step 1.
4. Scroll to
Save Changes
and press /II/SEL or to save.
Normal Priority
Normal Priority
is ON and WX
is OFF and WX
Priority is Off
Priority is ON
Check only
Checks only WX
Normal Priority
Priority channel
channel
No Alert
Alert displays
when 1050Hz
tone is detected
No Priority
No Priority
Operation
Operation
No Priority
No Priority
Operation
Operation
No Priority
No Priority
Operation
Operation
No Priority
No Priority
Operation
Operation
.
40
SAME Standby Mode
About SAME Signals
Each weather alert is preceded with a digitally encoded SAME
(Specific Area Message Encoding) signal, then a 1050 Hz tone.
The SAME signal includes a FIPS (Federal Information Processing
Standard) code and an event code that corresponds with the type of
alert being sent. The FIPS code format is:
Subdivisions
0-9 (0=entire area)
01-50 (00=all states)
Example: 048439 (0=entire area; 48=Texas; 439=Tarrant County)
n
Note: A current list of FIPS codes is located at:
www.NWS.NOAA.gov/NWR indexnw.htm.
Programming FIPS Codes
You can specify SAME alerts for up to ten locations by programming
the FIPS codes for the subdivision, state, or county. Before you can
use SAME Standby Mode, you must program at least one FIPS code.
1. Press
to activate Weather Mode, then press MENU.
2. Scroll to
SAME 1 Tag
and press
1 location.
3. Follow the on screen instructions to create and save the name.
4. Scroll down to
SAME 1 FIPS
for SAME 1.
5. Follow the on-screen instructions to enter and save the FIPS
code for your local area.
6. Scroll down to
SAME 1 Enable
the SAME 1 location.
7. Repeat steps 2-6 if you want to program SAME information for
other areas.
8. When finished, Scroll to
Save Changes
press MENU and follow the on-screen
to save changes, or
instructions to save changes and exit.
State
County
XXX (000=all counties)
to enter a name for the SAME
and press
to enter a FIPS code
and press
nable
/II/SEL or to e
and press
/II/SEL or
41