Page 2
Planar your support question. Talk to a Customer Service Representative To contact Planar's Customer First(TM) Technical Support Service call 1.866.PLANAR.1 (866.752.6271). This service is available 5am - 5pm Pacific Time, 8am - 8pm Eastern Time, Monday through Friday. Contact Us 24x7 Online Technical Support: http://www.planar.com/support...
Page 4
The information contained in this document is subject to change without notice. This document contains proprietary information that is protected by copyright. All rights are reserved. No part of this document may be reproduced, translated to another language or stored in a retrieval system, or transmitted by any means, electronic, mechanical, photocopying, recording, or otherwise, without prior written permission.
TABLE OF CONTENTS For Your Safety -----------------------------------------------------------5 For Your Safety General Notes ----------------------------------------- 7 Special notes on LCD monitors ------------------------------------------------------------ 7 Other notes Before You Operate The Monitor ---------------------------------------------------------------- 8 Features ----------------------------------- 8 Checking the contents of the package Installation Instructions ---------------------------------------------------------- 9 Power source -------------------------------------------------- 10...
FOR YOUR SAFETY Before operating the monitor, please read this manual thoroughly. This manual should be retained for future reference. FCC Class B Radio Frequency Interference Statement WARNING: (FOR FCC CERTIFIED MODELS) NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
Page 8
PRECAUTIONS Do not use the monitor near water, e.g. near a bathtub, washbowl, kitchen sink, laundry tub, swimming pool or in a wet basement. Do not place the monitor on an unstable cart, stand, or table. If the monitor falls, it can injure a person and cause serious damage to the appliance. Use only a cart or stand recommended by the manufacturer or sold with the monitor.
GENERAL NOTES SPECIAL NOTES ON LCD MONITORS The following symptoms are normal with LCD monitor and do not indicate a problem. • Due to the nature of the fluorescent light, the screen may flicker during initial use. Turn off the Power Switch and then turn it on again to make sure the flicker disappears.
User Manual 24-Pin DVI Cable Register Your Planar Products Today Thank you for choosing Planar. To assure you receive all the benefits of your Planar product and services, register your Planar product today. Visit our website to register your product at http://www.planar.com/support/product_registration.html...
INSTALLATION INSTRUCTIONS Power Source: 1. Make sure that the power cord is the correct type required in your area. 2. This LCD monitor has an internal Universal Power Supply that allows operation in either 100/120V AC or 220/240V AC voltage area (No user adjustment is required.) 3.
INSTALLATION INSTRUCTIONS (cont.) Connecting The Cables AC Power Cord 3. DVI Cable Turn off your computer before performing the procedure below. 1. Connect the female end of the AC power cord to the AC-in port on the back of the monitor. Connect the other end to a nearby AC-outlet. 2.
INSTALLATION INSTRUCTIONS (cont.) Tilt Adjustment For optimal viewing it is recommended to look at the full face of the monitor, then adjust the monitor's angle to your own preference. Hold the stand so you do not topple the monitor when you change the monitor's angle.
OPERATING INSTRUCTIONS EXTERNAL CONTROLS 1. -/ Volume Control 2. +/ Volume Control 3. SELECT • Power Button: Press this button to turn the monitor ON or OFF. • SELECT: Activates OSD menu or confirms function. • + /Volume: Increase volume or adjust function. •...
OPERATING INSTRUCTIONS (cont.) • 1<->2/RESET: When OSD menu is in active status, this button will act as EXIT-KEY (EXIT OSD menu) or go back to the previous menu. When OSD menu is in off status, press this button for 2 seconds to activate the Auto Adjustment function,press this button 7 seconds to ON/OFF DDC-CI function.
OPERATING INSTRUCTIONS (cont.) How To Adjust A Setting 1. Press the SELECT-button to activate the OSD window (Figure 5). 2. Press + or - to navigate through the functions. Once the desired function is highlighted, press the SELECT-button selected has a sub-menu, press + or - again to navigate through the sub-menu functions.
OPERATING INSTRUCTIONS (cont.) The descriptions for function control LEDS Main Main Menu Menu Menu Item Icon Luminance Contrast Brightness Image Focus Setup Clock Image H. Position Position V. Position Color Warm Temp. Cool sRGB User / Red User / Green User / Blue Menu Item...
Page 18
OPERATING INSTRUCTIONS (cont.) Main Main Menu Menu Icon Item Input Select OSD Setup Language Information Reset Exit Menu Menu Icon Item Analog Digital H. Position V. Position Timeout Language Information Description Select input signal from analog source(D-Sub) Select input signal from digital source (DVI) Adjust the horizontal position of the OSD.
TECHNICAL SUPPORT (FAQ) Problem & Question Power LED is not on No Plug & Play Picture is fuzzy Picture bounces or a wave pattern is present in the picture The power LED is ON (Amber) but there’s no video or no picture.
TECHNICAL SUPPORT (FAQ) (cont.) CLOCK (pixel frequency) controls the number of pixels scanned by one horizontal sweep. If the frequency is not correct, the screen shows vertical stripes and the picture has not correct width. FOCUS adjusts the phase of the pixel clock signal. With a wrong phase adjustment the picture has horizontal disturbances in light picture.
APPENDIX SPECIFICATIONS LCD Panel Input Display Colors Dot Clock Max. Resolution Plug & Play Power Consumption Input Connector Input Video Signal Maximum Screen Size Power Source Environmental Considerations Dimensions Weight (N. W.) Driving system TFT Color LCD Size 55.87cm(22") Pixel pitch 0.282mm( H )x 0.282mm( V ) Video R,G,B Analog Interface...
Page 22
APPENDIX (cont.) External Controls: Power Consumption Regulatory Compliance • Switch 1<->2/RESET • Volume • Volume • SELECT • Power Button • Functions Contrast • Brightness • Focus • Clock • H.Position • V.Position • (Warm) Color • (Cool)Color • SRGB Color temperature •...