For luminance keying, chroma keying or
external keying, apply effects such as slice and
slope to the key video ( page Vol.2-6).
5
Set the pattern position (where the key is
inserted) using the joystick.
Press the CENTER button to turn on, and the pattern
position is set to the center.
Press the HOLD button to turn on, and the joystick is
fixed to the current position.
NOTE
•
There are some patterns for which the position
cannot be adjusted with the joystick.
For more information, refer to “List of Key
Patterns” at the back of Volume 2.
•
For the patterns registered as direct patterns, the
settings of the effects and position applied to each
pattern are saved in memory and applied when the
pattern is called next time (if [MODE] in the [SETUP]
menu is set to [PRESET]). Any settings made for the
patterns not registered as direct patterns are not
saved in memory.
6
Set the pattern size (key size) using the rotary
Z control.
If a specific key pattern is selected. press the
ASPECT button to turn on, and the aspect ratio
of the pattern can be temporarily changed with
the ASPECT control. (When it is turned in the H
direction, the width (horizontal) is increased; when
it is turned in the V direction, the height (vertical) is
increased). When the button is turned off, the aspect
ratio returns to the value before change.
For patterns to which the aspect change function
can be applied, refer to “List of Key Patterns” at the
back of Volume 2.
7
Set the transition time (from combining start to
end) ( page 35).
8
Slide the transition lever to the B side (or A
side) or press the AUTO TAKE button.
When the AUTO TAKE button is pressed, it is lighted
and source video A is combined with B (or source
video B is combined with A).