•
Position setting values of patterns registered as direct
patterns
•
Button ON/OFF state
•
Time setting values (transition, DSK, and fade)
The factory default setting is [PRESET].
Changing Direct Patterns
[DIRECT PATTERN]
The patterns that are frequently used for transition and keys
are registered as “direct patterns.” These patterns can be
selected with the direct transition (or key) pattern buttons in
the PATTERN area.
The effect and position settings applied to the respective
patterns registered as direct patterns are saved in memory
and applied when the patterns are called next time (if
[MODE] in the [SETUP] menu is set to [PRESET]).
Any settings made for the patterns not registered as
direct patterns are not saved in memory. In addition, when
a pattern is called, the setting values common to the
applicable patterns are displayed in the menu.
The [DIRECT PATTERN] submenu of the [SETUP] menu
can be used to change direct pattern assignment to each
button.
Rotary 1
Rotary 2
Rotary 3
Rotary 4
Rotary 5
DIRECT
PATTERN
SETUP
SETUP
DEFAULT
To change a direct pattern
1
Select [SETUP] using the rotary 2 control, and
press the
key.
2
When the message [OK?] appears, press the
key again.
To stop the setting process, press the
key
while holding down the SHIFT key.
All the direct transition pattern buttons and direct
key pattern buttons that can be selected flash in the
PATTERN area.
3
Press the direct transition (or key) pattern
button of the pattern you want to change.
The selected button flashes.
4
Enter the number of the pattern you want to set
for transition or as the key using the numeric
keys in the numeric key area.