[Setup] Menu (Setup Operation) Screen; Setting The Startup Mode [Mode] - Panasonic AG-HMX100E Operating Instructions Manual

[SETUP] Menu
(Setup Operation) Screen
When the SETUP button is pressed, the [SETUP] menu
screen appears as shown below.
The [SETUP] menu is used to make the basic settings for
the entire unit.
POS. X 128 Y 128
Z 196
EVENT ME TIME
00 01:00
E F
SETUP
MODE POWER
RESET
AUDIO INPUT
VIDEO SETUP
VIDEO ASPECT
FORMAT 1080/59i
DIRECT
PATTERN SETUP
BUS TYPE
AB
MEMORY INT V TITLE
3
AUDIO CH L-CH
CH SDI1
AUDIO SOURCE AUX/MIC
FADER CP PAIR PAIR
AUDIO ALIGN.
LEVEL 0dB
PC1 FORMAT
ANALOG SXGA
PC2 H POSI V POSI
30
GEN. H PHASE
LOCK 1000
FILE EMPTY
1 SAVE
SYSTEM1 TIME GPI
SEC
SYSTEM2 P.SAVE SCR SAVE
OFF
RS-232C B.RATE DATA L.
9.6k 8BITS
3D MODE FORMAT
OFF
Rotary 1 Rotary 2 Rotary 3
Scroll the screen to display.
* 20dB (AG-HMX100P) or 18dB (AG-HMX100E)
1
22
PATTERN INT
3021 WHT
AUX WFM
SDI1 SDI1
SETUP
- - - -
3
R-CH OSD
1 2 ON
HEAD
dB*
1
A.SET
ON
PHASE CLOCK
10 16 1688
ME
HOURS M.
10 OFF
PARITY
NONE PJ
- -
Rotary 4 Rotary 5

Setting the Startup Mode [MODE]

The [MODE] submenu of the [SETUP] menu is used to
specify how to reproduce the stored settings when this unit
is restarted (startup mode).
Rotary 1 Rotary 2 Rotary 3
MODE POWER
RESET
RESET
PRESET
FACTORY
To reset settings other than basic
settings to the factory default settings
when the unit is restarted
Set [POWER] to [RESET] (reset mode) using the rotary 2
control.
Settings other than [SETUP] menu settings, direct pattern
settings, event memory settings, file settings, and key learn
settings are reset to the factory default settings.
To reset all settings to the factory default
settings when the unit is restarted
Reset all settings to the factory default settings.
1
Set [POWER] to [FACTORY] (factory default
mode) using the rotary 2 control, and press the
key.
2
When the message [OK?] appears, press the
key.
To cancel the file save, press the
holding down the SHIFT key.
3
When the message "Please Wait..." appears
and then "TURN POWER OFF" appears, turn
off the power and restart the unit.
To restore the last settings when the unit
is restarted
Set [POWER] to [PRESET] (preset mode) using the rotary 2
control.
The following types of data are stored, and applied when
the unit is started next time.
• [INT VIDEO] menu setting values
• [COLOR EFFECTS], [VIDEO EFFECTS], and [AUDIO
EFFECTS] menu setting values
• Combinations of patterns registered as direct patterns
and numbers
• Setting values of effects applied to the patterns
registered as direct patterns
Rotary 4 Rotary 5
key while