Omron BP652 Instruction Manual page 17

SETTING THE HEART GUIdE INdICATOR
2. Press the MEM button to select the buzzer setting.
If the Heart guide indicator is "on1" or "on2":
on1: The buzzer sounds only when the monitor is in proper position.
on2: The buzzer sounds a series of two short blips if your wrist is too far away
from the measuring position, and beeps when your wrist is in the proper
position.
oFF: The buzzer will not sound.
If the Heart guide indicator is "oFF":
on: The buzzer sounds when pressing any buttons.
oFF: The buzzer will not sound.
RESETTING TO THE DEFAULT SETTING
The Heart guide indicator is set "on1", the wrist for measurement is set " ", and the
buzzer is set "on1" as default.
To reset to the default setting, press and hold the SET button while in the setting mode,
then press the START/STOP button simultaneously for more than 2 seconds.
17