B Urn P Ot C Leaning; Leaning G Lass; Sh Rawer Emoval Nd Leaning - Lennox Hearth Products Winslow PS40 Installation And Operation Manual

Cleaning and Maintenance
Unplug and let the Winslow™ PS40 stove cool before per-
forming any maintenance or cleaning. Some brands of pellets
produce more ash and clinkers than others. Therefore the
frequency of performing the following cleaning procedures
depends to a great degree on the quality of the pellets burned.
Not cleaning this unit will cause it to burn poorly and will
void your stove's warranty.
b p c
urn ot Leaning
The combustion fan comes on at high speed once an hour
to blow the byproducts of combustion out of the burn pot.
However, the burn pot should be cleaned more throughly
after burning about 10 bags of pellets. The burn pot has
a number of holes in the bottom and sides that provide
combustion air to the pellets. The extreme temperatures in
the burn pot can cause the impurities in the pellets to form
ash and clinkers. When the stove is cool, open the front
door and lift out the cast iron burn pot. Scrape the inner
bottom and sides of the pot with a screwdriver to remove
all ash and clinkers from these surfaces. Make sure all the
holes in the pot are open. Place the burn pot in the hole
from which it was removed. Make sure the high side of the
pot is rotated toward the front of the stove (see Figure 43).
Push the burn pot down so surface A is tight against the
steel supporting the pot. Do not substitute any other grate
or pot for use in this stove.
c g
Leaning Lass
Caution: Do not open the front door when the stove is hot.
To open the door, follow the first two steps listed in front
Door Removal (see page ). Clean the glass using a soft
cloth or paper towel and Windex or wood stove window
cleaner. A damp cloth with a small amount of ash from
the firebox can also be used to clean the glass.
a d r
sh rawer emovaL and
Caution: Do not remove the ash drawer when the stove
is hot. To remove the ash drawer, swing open the left and
right side doors. Rotate the lever on latch b (see figure
) out from the stove to release the ash drawer. Do the
same with the latch on the right side of the stove. Pull the
ash drawer forward and away from the stove.
Caution: Disposal of Ashes - Ashes should be placed
in a metal container with a tight fitting lid. The closed
container should be placed on a non-combustible floor or
the ground - well away from all combustible materials,
pending final disposal. If the ashes are disposed of by
burial in soil or otherwise locally dispersed, they should
be retained in the closed container until all cinders have
been thoroughly cooled.
c
Leaning
NoTe: DIAGRAMS & ILLUSTRATIoNS ARe NoT To SCALe.
Reinstall the ash drawer by inserting the drawer in the stove
and refastening the left and right latches securely. Note that
if the ash drawer does not seal tightly to the stove, the control
board may detect a leak and shut the stove down.
High Side of burn Pot Goes
Toward front of Stove
figure 
Latch
Latch
figure 
A
B
b
19