Rick Anel Nstallation Nstructions; Brick Panel Installation - Lennox Hearth Products Winslow PS40 Installation And Operation Manual

brick Panel Installation

option: Part #7900
Kit Contents:
- Brick Panel (A)
- 4 Tap Tights (B)
Tools Required:
- Drill (90° drill recommended)
- #18 drill bit
- 5/32 allen wrench
A
figure 
Note: The brick panel comes pre-painted with Metallic
black paint. The brick panel may be painted with any
color of Stove bright® high-temp paint (paint may dis-
color with use).
1. Remove the front door of the pellet stove. To remove
the front door, open the two side panels, swing open the
front door, and lift it up and off of its hinges. Remove the
optional log set, if present, and the burn pot.
figure 
1
B
NoTe: DIAGRAMS & ILLUSTRATIoNS ARe NoT To SCALe.
2. Remove all pellets and ash from the firebox to ensure a
proper fit for the brick panel.
3. Insert the brick panel, top first, as shown in Figure 35.
The two cut out corners should be at the bottom.
figure 5
4. Make sure that the brick panel is centered, with equal space
on either side of the auger tube. While holding the panel
in place, use the drill with a #18 drill bit to drill out the four
holes in the back of the firebox, as shown in Figure 36.
figure 6