Lennox Hearth Products Winslow PS40 Installation And Operation Manual page 12

4. Place one washer on each stud. Using a 3/8" nut driver,
snug up the nuts on each piece of trim. Do not finish
tightening the nuts yet. See Figure 27.
5. There should be approximately a 7/8" (22mm) gap between
the top edge of the upper trim and the top edge of the
door and a 1-1/2" (38mm) gap between the bottom trim
to the bottom of the door. Visually inspect the alignment
of the trim and adjust if necessary. See Figure 28.
6. Finish tightening nuts. CAUTIoN - Do NoT oVeR-TIGHTeN
NUTS, DIMPLING of THe TRIM WILL oCCUR!!!
figure 7
1
figure 8
NoTe: DIAGRAMS & ILLUSTRATIoNS ARe NoT To SCALe.